Non Load Bearing Roof Truss

Internal wall brackets are used to connect internal non loadbearing walls to roof trusses at maximum 1800mm centres.

Non load bearing roof truss.

It can take various forms and often used for aesthetic purposes adding height and focal interest to the ceiling. A rolling node is assigned to provide support in only one direction often the y direction of a truss member. This type of truss is perfect for the dining room living room great room and kitchen. For many multi family projects floor and roof trusses joists span from unit wall to unit wall while interior non load bearing walls tend to fall near the center of the floor span.

To enable the roof truss to deflect under loads nails to the truss must be installed at the top of the slotted holes and not hammered home to allow a loose fit only. For example a gable end truss may be designed with support members that transmit the roof weight load outward to the side walls allowing the end wall directly below it to have breaks or openings in it that would otherwise be impossible. One top plate and a space between the bottom chord of the truss and the top of the wall non load bearing. An example of a non load bearing partition wall can be seen on the left.

When joists trusses are perpendicular to the wall and bear on the top of the wall that wall is bearing wall. A pitch truss with a sloping or non sloping vertical interior ceiling detail. If there are two plates refer to an engineer. Engineered roof truss systems may be designed to eliminate the need for load bearing walls or change where the bearing walls are located.

The remaining third node of each triangle is known as the load bearing node. Actually a quick way to determine if the wall is bearing is to cut hole at the top to see if it has one or two top plates. An example of a load bearing wall call be seen on the right.